Hardware tool knowledge: maintenance and maintenance of pneumatic tools
Release time:
2022-09-08 14:49
Six basic points of pneumatic tool operation and maintenance
1. Correct replacement gas supply system:
The inlet pressure at the tool inlet (non-air compressor outlet pressure) is generally 90PSIG (6.2Kg/cm^2). Too high or too low will damage the performance and life of the tool.
The air intake must contain sufficient lubricating oil, so that the air motor in the tool can be fully lubricated (you can place a white paper at the exhaust of the tool to check whether there is oil stains, normally there are oil stains).
The intake air must be completely free of moisture. It is inappropriate to shrink the air without an air dryer.
2. Do not arbitrarily remove the parts of the tool and then operate it, except that it will affect the operator's safety switch and cause the tool to be damaged.
3. If the tool is slightly faulty or cannot achieve the original function after use, it cannot be used any more, and it should be checked immediately.
4. Regularly (about once a week) check and maintain tools, add grease to rotating parts such as bearings, and add oil to air motor parts.
5. When using various tools, be sure to follow various safety regulations and operating instructions.
6. It is necessary to choose appropriate tools for work. Too large tools can easily cause work injury, and tools that are too small can easily cause tool damage.
Related News
2022-09-08
