Precautions during the use of pneumatic tools

If you want to use the air tool for a long time, then you have to maintain it to prolong the service life of the air tool.

1. Correct use of lubricating oil

In order to maintain the best working performance of the air tool, it is best to add one to two drops of special oil for air tools before each use of the tool, which is very critical to the service life of the air tool. If the air tool oil is not often added before the use of the air tool, it will often cause damage to the shaft and blades of the air tool. When the lubricating oil is dripped, it is generally dripped at the pneumatic air inlet, and one or two drops are sufficient.

2. Selection of air pressure before use

1. To set the ideal air pressure, start from low pressure and gradually increase the pressure until a satisfactory effect is achieved. Before using the tool, check the air pressure and never exceed the specified air pressure, otherwise the tool may burst.

2. The source must use dry and dust-free ordinary compressed air, and it is strictly forbidden to use oxygen and any flammable gas to avoid accidental injury.

3. When the nail gun and the trachea are connected, unless the nailing work is performed, do not hold the trigger, so as to avoid accidental firing.

4. After each work, be sure to separate the trachea from the tool

5. When multiple nail guns use a compressor, the capacity of the compressor must match it, otherwise it will cause insufficient air pressure.

3. Safety precautions when using pneumatic tools

1. Please wear protective glasses when working

2. Do not bring jewelry items such as rings, necklaces and bracelets at work

3. Do not face anyone with the muzzle at any time, and do not pull the trigger when installing the nails.

4. It is strictly forbidden to hit more than two nails at the same nail position to prevent the second nail from hitting the first nail cap and splashing the nails

5. When using a tool, do not use it as a hammer to hit hard

6. Do not use too long air hoses

7. Don’t stand on shelves and ladders to drive nails

8. Do not use the tool when it is found to be leaking

9. In any case, do not grab and lift the air hose connecting the tool, you must use the handle of the tool

10. The original design, structure and function combination of the tool cannot be arbitrarily changed

11. When suspending the use of the tool, do not hold the trigger all the time to avoid unnecessary nailing

12. Be sure to separate the air tube from the tool during any maintenance, overhaul and clearing of nail gun blockages

13. Always clean up the work area and keep it clean to avoid personal injury caused by site mixing